摘 要
本设计题目为本田125安装板成型成型工艺及模具设计，体现了板类塑料零件的设计要求、内容及方向，有一定的设计意义。通过对该零件模具的设计，进一步加强了设计者成型模设计的基础知识，为设计更复杂的成型模具做好了铺垫和吸取了更深刻的经验。
本设计运用塑料成型工艺及模具设计的基础知识，首先分析了塑件的成分及性能要求，为选取浇口的类型做好了准备；然后估算了塑件的体积，便于选取成型机及确定型腔数量；最后分析了塑件的特征，确定模具的设计参数、设计要点及推出装置的选取。
本塑件的两侧都有螺纹孔，采用顶杆顶出，有利于模具的简化，工作效率较高，这是这种模具的普遍之处。这种机构脱模可靠，非常适合在本副模具中使用。
关键词：成型模 螺纹孔 顶杆
Abstract
The design of the design for the Honda 125 installation board molding process and mold design, reflects the board of plastic parts design requirements, content and direction, a certain design significance. Through the design of the parts of the mold, to further strengthen the designer of the basic knowledge of mold design for the design of more complex molds pave the way and draw a more profound experience.
The design of the use of plastic molding process and the basic knowledge of mold design, the first analysis of the composition of plastic parts and performance requirements for the selection of the type of gate ready; and then estimate the volume of plastic parts, easy to select the molding machine and determine the type The number of cavities; the final analysis of the characteristics of plastic parts to determine the mold design parameters, design points and the introduction of the device selection.
The plastic parts on both sides of the threaded hole, the use of mandrel ejected, is conducive to the simplification of the mold, high efficiency, which is the common place of this mold. This mechanism is very reliable, very suitable for use in the vice mold.
Key words: forming mold screw hole mandrel
目录
